Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: USP Compact (rear sight cut depth is .200"" instead of .160"") USP Expert USP Elite VP9 VP40 P30 P30L P30SK HK45 HK45C
Entferne einfach die Kimme deines Gewehrs und ersetze sie durch die EGW-Montage, um dein Vortex Razor, C-More RTS oder STS Rotpunktvisier zu montieren. Du kannst die Montage jederzeit abnehmen und deine Kimme wieder einsetzen. Montagematerial ist enthalten. Installationsanleitung Entferne die Kimme* Installiere die EGW Sichtmontage in der Nut Ziehe die Schraube fest (sofern zutreffend) Platziere das Rotpunktvisier auf der EGW Sichtmontage (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Sichtmontage erleichtert die Entfernung und schützt das Rotpunktvisier vor Loctite.) Trage blauen Loctite auf die bereitgestellten Montageschrauben auf Ziehe die Montageschrauben mit 15in/lbs fest Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel zur Installation. Diese Montage passt nicht auf: USP Compact (die Tiefe des Kimmeschnitts beträgt .200"" statt .160"") USP Expert USP Elite VP9 VP40 P30 P30L P30SK HK45 HK45C