EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. Does not work with Rock Island 1911 or EAA/Tanfoglio Witness with LPA/Bomar style rear sights.
I mirini a punto rosso EGW sono progettati per essere installati da sinistra a destra (con la bocca rivolta in avanti). La guida ha un'inclinazione progressiva per facilitare l'installazione. Basta rimuovere il mirino posteriore della tua arma e sostituirlo con il montaggio EGW per installare il tuo Vortex Viper/Venom, Burris FastFire o Docter mirino a punto rosso. Puoi rimuovere il montaggio e ripristinare il tuo mirino posteriore in qualsiasi momento. Hardware di montaggio incluso. Istruzioni per l'installazione Rimuovi il mirino posteriore* Installa il montaggio EGW nella guida Stringi la vite di blocco (se applicabile) Posiziona il mirino a punto rosso sul montaggio EGW (mettere un piccolo pezzo di carta tra il mirino a punto rosso e il montaggio faciliterà la rimozione e impedirà al Loctite di toccare il mirino a punto rosso.) Applica Loctite blu alle viti di montaggio fornite Serrare le viti di montaggio a 15in/lbs 2 Viti a testa a bottone - Fornite per i mirini Vortex Viper e Venom 2 Viti a testa piatta - Fornite per i mirini Burris FastFire e Docter Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione. La modifica della tua arma potrebbe annullare la garanzia del produttore. Questo prodotto deve essere installato e controllato da un armaiolo qualificato. Non si assume alcuna responsabilità per danni o lesioni che possono derivare da un'installazione o un uso improprio di questo prodotto. Non è compatibile con Rock Island 1911 o EAA/Tanfoglio Witness con mirini posteriori in stile LPA/Bomar.