This mount was designed for use with the Williams FP-GR TK peep sight. The corresponding front sight and block from Williams are: Lyman Globe Front Sight Williams Rear Sight Top of the receiver to the top of the rear sight dovetail is .330" Top of the receiver to the top of the picatinny rail is .45" This rail is ambidextrous. This mount is milled on both sides for bolt clearance on left or right handed models. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW's one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. They machine these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately). The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Mehr...
64.964.91CHF
Artikel-Nr.: 296000612 EGW SAVAGE RASCAL CUT FOR WILLIAMS SIGHT PICATINNY BASE 0 MOA Herstellerproduktnummer: 41965841370113675
This mount was designed for use with the Williams FP-GR TK peep sight. The corresponding front sight and block from Williams are: Lyman Globe Front Sight Williams Rear Sight Top of the receiver to the top of the rear sight dovetail is .330" Top of the receiver to the top of the picatinny rail is .45" This rail is ambidextrous. This mount is milled on both sides for bolt clearance on left or right handed models. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW's one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. They machine these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately). The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.