A hand operated, carbide cutter easily trims excess material from the bottom barrel lug when fitting custom or factory barrels to 1911 autos. These cutters remove material from the barrel lugs in a parallel fashion, and with the correct height and radius, to help produce the best possible lockup. It is recommended to use the 0.186” cutter first, then progress to the 0.195” cutter if more material needs to be removed. Follow with careful hand fitting to achieve a firm, non-binding barrel-to-slide fit. Start small and check your work often. It is possible, with some slide/barrel combinations, that the 0.195” cutter could remove more material than necessary. Fits all 1911 Auto, Commander, Officer, single and double-stack frames. The 0.186” Lug Cutter, and 0.195” model are available with or without the handle. The handle is also available individually.
SPECS: 1' (2.5cm) diameter knob; 2.07' (5.25cm) long shank. .186' (4.72mm) or .195' (4.95mm) diameter cutters. Complete instructions included.
Il cutter in carburo a mano rimuove facilmente il materiale in eccesso dalla parte inferiore del lug del barile quando si adattano barili personalizzati o di fabbrica alle 1911 Autos. Taglia i lug del barile in modo parallelo, con l'altezza e il raggio corretti, per aiutare a produrre il miglior bloccaggio possibile. Utilizzare prima il cutter da .186', quindi passare al cutter da .195' se è necessario rimuovere ulteriore materiale. Seguire con un attento adattamento a mano per ottenere un adattamento solido e non vincolante tra il barile e il carrello. Iniziare con piccole modifiche e controllare frequentemente il lavoro. È possibile, con alcune combinazioni di carrello/barile, che il cutter da .195' possa rimuovere più materiale del necessario. Si adatta a tutte le 1911 Auto, Commander e Officers ACP, telai a singola e doppia fila.
SPECIFICHE: manopola di diametro 1' (2.5cm); stelo lungo 2.07' (5.25cm). Cutter di diametro .186' (4.72mm) o .195' (4.95mm). Istruzioni complete incluse.