The Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for an M-Lok version of our Finger Stop for Picatinny rails, and features a slim front-to-back profile and slight radius across both faces. The Indexer can be used in a variety of ways, but the main intent is to place it between two fingers (usually index and middle). This typically places it further forward on the handguard, which also means it doesn't get in the way when transitioning to kneeling or prone shooting positions, where most people move their support hand towards the rear. Used in this manner, the Indexer makes it much easier to pull the rifle into your shoulder and maintain control while shooting. Additionally, the wider, flatter profile of the Indexer functions very well as a hand stop or barricade stop, and also works as a forward limit to prevent your fingers from slipping off shorter handguards onto a hot barrel or suppressor. Height: 1.0" Width: 0.58" Length: 1.5" Weight: 0.6 oz The Indexer is CNC machined from 6061-T6 aluminum and MIL-A-8625 Type III hard coat anodized. Requires an IP25/T25 Torx wrench for installation (not included). Made in the USA.
L'Indexer Arisaka è un'estensione dei nostri accessori a basso profilo e controllo minimo. È stato sviluppato in risposta alla richiesta degli utenti finali per una versione M-Lok del nostro Finger Stop per guide Picatinny, e presenta un profilo sottile da davanti a dietro e una leggera curvatura su entrambe le facce. L'Indexer può essere utilizzato in vari modi, ma l'intento principale è posizionarlo tra due dita (di solito indice e medio). Questo lo colloca tipicamente più avanti sulla guardia, il che significa anche che non ostacola il passaggio a posizioni di tiro in ginocchio o prona, dove la maggior parte delle persone sposta la mano di supporto verso la parte posteriore. Utilizzato in questo modo, l'Indexer rende molto più facile tirare il fucile verso la spalla e mantenere il controllo durante il tiro. Inoltre, il profilo più ampio e piatto dell'Indexer funziona molto bene come hand stop o barricade stop, e funge anche da limite anteriore per prevenire che le dita scivolino da guardie più corte su un canna calda o un soppressore. Altezza: 1.0" Larghezza: 0.58" Lunghezza: 1.5" Peso: 0.6 oz L'Indexer è realizzato con lavorazione CNC in alluminio 6061-T6 e anodizzato con rivestimento duro MIL-A-8625 Tipo III. Richiede una chiave Torx IP25/T25 per l'installazione (non inclusa). Prodotto negli Stati Uniti.