Two specially ground punches make fitting the 870 ejector spring and housing onto Remingtons' unique 2-step rivet a snap! The hole in the face of the #1 tool allows you to fasten the ejector housing to the receiver with the lower portion of the rivet. The #2 tool is then used to secure the ejector spring within the ejector housing with the upper portion of the rivet. Deluxe Kit combines the above two punches with an ejector spring rivet cutter that lets you take off just the peened area of the front rivet. Often lets you re-peen the existing rivet.
SPECS: Punches - Hardened steel, blue finish. 2 punches, each 3-½" (8.8cm) long. Rivet Cutter - Steel shaft and hardened steel cutter. 2-½" (6.3cm) long, .31" (7.8mm) shaft diameter, .143" (3.6mm) cutter diameter.
Deux poinçons spécialement affûtés facilitent l'installation du ressort d'éjecteur et du boîtier sur le rivet unique à 2 étapes de Remington ! Le trou sur la face de l'outil #1 te permet de fixer le boîtier d'éjecteur au récepteur avec la partie inférieure du rivet. L'outil #2 est ensuite utilisé pour sécuriser le ressort d'éjecteur à l'intérieur du boîtier d'éjecteur avec la partie supérieure du rivet. Le kit deluxe combine les deux poinçons ci-dessus avec un coupeur de rivet de ressort d'éjecteur qui te permet d'enlever juste la zone peignée du rivet avant. Cela te permet souvent de re-peigner le rivet existant.
SPÉCIFICATIONS : Poinçons - Acier trempé, finition bleue. 2 poinçons, chacun de 3-½" (8,8 cm) de long. Outil de coupe de rivet - Tige en acier et coupeur en acier trempé. 2-½" (6,3 cm) de long, diamètre de tige de .31" (7,8 mm), diamètre du coupeur de .143" (3,6 mm).