Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount fits: Smith & Wesson K Frame Revolvers Smith & Wesson L Frame Revolvers Smith & Wesson N Frame Revolvers Smith & Wesson X Frame Revolvers If your revolver is not drilled and tapped this mount will not work. The best way to verify that it is/is not drilled and tapped is to open the cylinder and check the rib underneath. There should be through holes that are drilled and tapped. If there are not (like the above image) this mount will not work without you having the gun drilled and tapped. You can have a competent and qualified gunsmith drill and tap the top strap with the standard S&W hole pattern which will allow you to use our mount.
Rimuovi semplicemente il mirino posteriore della tua arma e sostituiscilo con il montaggio EGW per installare il tuo Vortex Razor, C-More RTS o STS red-dot sight. Puoi rimuovere il montaggio e ripristinare il tuo mirino posteriore in qualsiasi momento. Hardware di montaggio incluso. Istruzioni per l'installazione Rimuovi il mirino posteriore* Installa il montaggio EGW nel dovetail Serrare la vite di fissaggio (se applicabile) Posiziona il red dot sight sul montaggio EGW (mettere un piccolo pezzo di carta tra il red dot sight e il montaggio renderà più facile la rimozione e terrà il Loctite lontano dal red dot sight.) Applica Loctite blu alle viti di montaggio fornite Serrare le viti di montaggio a 15in/lbs Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione. Questo montaggio si adatta a: Revolver Smith & Wesson K Frame Revolver Smith & Wesson L Frame Revolver Smith & Wesson N Frame Revolver Smith & Wesson X Frame Revolver Se il tuo revolver non è forato e filettato, questo montaggio non funzionerà. Il modo migliore per verificare se è/ non è forato e filettato è aprire il tamburo e controllare la cresta sottostante. Dovrebbero esserci fori passanti che sono forati e filettati. Se non ci sono (come nell'immagine sopra) questo montaggio non funzionerà senza che tu faccia forare e filettare l'arma. Puoi far forare e filettare il top strap da un armaiolo competente e qualificato seguendo il modello di foratura standard S&W, il che ti permetterà di utilizzare il nostro montaggio.