The WFT 2 is the next generation of WFT trimmers. The two main improvements are the ability to trim up to 45 caliber and interchange trim chambers. The WFT 2 has a half inch shaft and requires a half inch chuck to drive it. The feature most customers asked for was the ability to interchange trim chambers. Instead of press fitting the trim chambers, like the original WFT, the trim chambers on the WFT 2 are a slight slip fit in bearing with a groove cut for an O-ring which creates a press fit. Changing out trim chambers is accomplished by removing the cutter and pushing out the trim chamber with the knock-out dowel that is provided. Installing the trim chamber is accomplished by setting the trim chamber on a flat surface and steadily pushing the housing onto the trim chamber. Setting the cutter depth is easily adjusted by placing a “master case” in the trim chamber and sliding the cutter up to the case mouth and tightening down the set screws. Trimming is just as precise and clean as with our original trimmer. The trim chamber selection on the WFT 2 is by specific cartridge, but still trims by case family-just order the largest chamber in the family that you intend to trim. This unit and its inserts do not chamfer or deburr the case moouth of the cartridge case as it is trimmed. If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015
Il WFT 2 è la nuova generazione dei trimmer WFT. I due principali miglioramenti sono la capacità di trimmare fino al calibro 45 e l'intercambiabilità delle camere di trimmatura. Il WFT 2 ha un albero da mezzo pollice e richiede un mandrino da mezzo pollice per essere azionato. La caratteristica richiesta dalla maggior parte dei clienti era la possibilità di intercambiare le camere di trimmatura. Invece di adattare a pressione le camere di trimmatura, come nel WFT originale, le camere di trimmatura del WFT 2 sono progettate per un leggero adattamento a scorrimento in un cuscinetto con una scanalatura per un O-ring che crea un adattamento a pressione. Cambiare le camere di trimmatura avviene rimuovendo il cutter e spingendo fuori la camera di trimmatura con il perno di espulsione fornito. L'installazione della camera di trimmatura si ottiene posizionando la camera di trimmatura su una superficie piana e spingendo con decisione il corpo sulla camera di trimmatura. La regolazione della profondità del cutter è facilmente effettuabile posizionando un “master case” nella camera di trimmatura e facendo scorrere il cutter fino alla bocca del bossolo e serrando le viti di regolazione. Il trimmaggio è preciso e pulito come con il nostro trimmer originale. La selezione della camera di trimmatura sul WFT 2 è specifica per ogni cartuccia, ma continua a trimmare per famiglia di bossoli: basta ordinare la camera più grande della famiglia che si intende trimmare. Questa unità e i suoi inserti non smussano né sburrano la bocca del bossolo della cartuccia mentre viene trimmato. Se non riesci a trovare la cartuccia di cui hai bisogno, ti preghiamo di contattare il nostro Dipartimento Ordini Speciali al numero 800-741-0015.